Dust Boot v9 Bundle for Onefinity

Honestly have to say I'm a little disappointed with this one. First off, they sent the wrong size thumb screw. Contacted customer support and they did remedy the problem. Just had to wait another week for shipping. Second, the arm for the dust boot that appears to be 3D printed separated while the screw was inserted in to it. Had to super glue that piece back together in order for it to work. it is holding for now. have not put it to use yet to see if it will hold. As for everything else I have purchased from PWNCNC, excellent products.

This dust boot works extremely well! It was easy to put together. The only issue I had was if my dust collector is off and I move the router up the Y axis, the end which has the hose connected to it, drags on the spoilboard. I think I’ll try adding a section of 4” straight pipe between the boot and the ultimate hose clamp to keep the dust boot level when the dust collector is off. Currently I just have the 4” dust hose attached to the boot and clipped into the ultimate hose clamp and on to the main line of the dust collector. When I turn on the dust collector the hose retracts and the dust boot sits level. So I figure if I change the section between the boot and the clamp it will hold the boot level even if the dust collector is off. Other than that, the V9 Dust boot is perfect.

We cut a lot of XLPE for and the stuff loves to stick to rails and ball screws and clog them up. After an 70 minutes long cut the not a bit of foam stuck to any of the troublesome components of the cnc.

excellent overall but in first homing left arm got hooked on tramming bolt and cracked it, however I was able to repair it and after replacing tram bolts with grub screws it is good to go, so check your clearances before first use. One suggestion I have is that there would be option for brush length since it comes with 1" brush witch doesn't leave much clearance for clamps especially on thin material. I will order 2" brush when it comes available.

Fantastic!!!